ClareControls CH-THSTAT-W Manual do Utilizador descarregar pdf (Página 12)

Doc ID 2014-05-223 • Rev 02 Page 12

WiFi Setup

Select

Key xxxxxxxx

IP 0.0.0.0

SUB 0.0.0.0

GW 0.0.0.0

Done

• Upon successful completion, the WiFi Network Status screen will be displayed

SSID

Select SSID and press the “Select” button to scan for available networks.

After the thermostat completes a network scan, the available networks will be displayed.

Use the up/down arrow buttons to scroll through the available networks

Press Join to join the selected network

Press Scan to scan again

Press New to enter a new SSID network name to join

DHCP Configuration

If the network router supplies IP address Dynamically (DHCP):

• Select “SSID” from list shown on screen, press “Join” button

• Or, press the Scan button to rescan for SSID

• Or, manually enter the SSID network name (Case / character capable)

• Select DHCP enabled (this is the default mode)

• Once the router / SSID is selected, the WiFi radio will auto-detect the appropriate

security protocol

• Or, manually select the security type (Adhoc, WPA1, WPA2, WPA1+WPA2,

WEP)

• Enter the security key (Case sensitive and character capable)

• Select Done to save settings

Security

Select the security type for the network selected: Adhoc, Open, WEP, WPA1,WPA2

Key

Enter the Passphrase for the network selected.

IP Address (for static IP configurations)

To set a Static IP address:

• Disable DHCP by pressing the “-“ key

• Enter IP Address (if static IP)

• Enter the Subnet Mask

• Enter the Default Gateway address

• Enter the DNS address

• Enter the Port number. The WiFi radio communicates on Port 2000, this

should be left in the default setting

• Enter the Channel number. Auto mode is the default (recommended)

• Select Done to save settings

Ad Hoc Mode

The Wi-Fi radio can also be placed into Ad Hoc mode which enables Peer-to-Peer

communication without a network router.

• Select Ad Hoc in the Setup menu. The default mode is Disabled

• Press the “+” key to change to Enabled

o sets the thermostat IP address to: 169.254.1.1

o sets the Subnet to: 255.255.0.0

• Select Done to save settings

Shows network SSID, signal strength and open / locked network status

WiFi Networks

Join

Network1

Network2

Network3

Network4

Done

IIII

III

Scan

New

1 2 ... 7 8 9 10 11 12 13 14

Comentários a estes Manuais

Sem comentários

ClareControls CH-THSTAT-W Manual do Utilizador Página 12

Comentários a estes Manuais

Manuais e produtos relacionados com Termóestatos ClareControls CH-THSTAT-W