ClareControls CH-THSTAT-W Manual do Utilizador descarregar pdf (Página 6)

DCN: 2012-11-222-1 Page 6

Max Heat SP Range: 40F to 109F (4C-43C) Default: 90F (32C)

Sets the maximum heating setpoint value.

Will not ramp or accept setpoints higher that this maximum.

Min Cool SP Range: 44F to 113F (6C-45C) Default: 60F (15C)

Sets the minimum cooling setpoint value.

Will not ramp or accept setpoints lower than this minimum.

Minimum Run Time (MRT) Range: 1- 9 Minutes Default: 3

Sets the minimum run time before a heating/cooling cycle can turn off.

Sets heating/cooling cycle time. Prevents rapid cycling.

Minimum Off Time (MOT) Range: 5-9 Minutes Default: 5

Sets the minimum off time before another heating/cooling cycle can begin.

Provides compressor short cycle protection.

Fan Cycler

The fan cycler function cycles the HVAC system fan for an ON period followed by an Off

period continuously. Used to provide minimum air ventilation requirements.

When the Fan ON time is set to a value greater than 0, an additional “Cycler” FAN mode is

present when pressing the FAN button.

Fan ON Time Range: 0-120 minutes Default: 0 (=OFF)

Fan OFF Time Range: 10-120 minutes Default: 10

Remote Sensors Submenu Sensor Setup

RS1 Type A curve, Type 2, Type 3 Default: Type 3

RS2 Type Range: A curve, Type 2, Type 3 Default: Type 3

RS2 Location Range: IN (indoors), OUT (outdoors) Default: IN

Restore Defaults Range: Yes, No Default: No

Restores all settings to factory defaults.

Press Yes to restore defaults,

Press No to exit and not restore defaults

1 2 3 4 5 6 7 8 9

Sem comentários

ClareControls CH-THSTAT-W Manual do Utilizador Página 6