ClareControls CH-THSTAT-W Guia do Utilizador descarregar pdf (Página 13)

Clare Controls IP Network Camera User Guide 5

Network connection

If you want to set the network camera via a LAN (Local Area Network), refer to “Setting

the network camera over a LAN” on page 5.

If you want to set the network camera via a WAN (Wide Area Network), refer to “Setting

the network camera over a WAN” on page 7.

Setting the network camera over a LAN

To view and configure the camera via LAN, you must connect the network camera in

the same subnet as your computer. Install the SADP software to search for and change

the IP of the network camera.

Note: For the detailed introduction of SADP, refer to Appendix 1.

Wiring over a LAN

The following figures show the two ways for establishing the cable connection of a

network camera and a computer.

To test the network camera, connect it directly to the computer with a network cable, as

shown in Figure 1.

Refer to Figure 2 to set the network camera over a LAN, via a switch or using a router.

Figure 1: Connecting directly

Figure 2: Connecting via a switch or a router

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 91 92

Sem comentários

ClareControls CH-THSTAT-W Guia do Utilizador Página 13