ClareControls CH-THSTAT-W Guia do Utilizador descarregar pdf (Página 87)

Clare Controls IP Network Camera User Guide 79

Note: If you want to connect the camera by the RS-232 port, the parameters of the

RS-232 must match the parameters configured here.

2. Click Save.

RS-485 settings

The RS-485 serial port is used to control the PTZ of the camera. Configure the PTZ

parameters before you control the PTZ unit.

To configure RS-485 settings:

1. Enter RS-485 Port Setting interface.

Configuration > Advanced Configuration > System > RS485

2. Set the RS-485 parameters and click Save to save the settings.

By default, the Baud Rate is set as 9600 bps, the Data Bit is set to 8, the stop bit is

set 1, and the Parity and Flow Control is set to None.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92

Clare Controls IP Network 1
Cameras User Guide 1
Disclaimer statement 4
Content 5
Important information 9
Safety warnings and cautions 10
Advisory messages 11
System requirement 12
Network connection 13
Figure 3: SADP interface 14
Static IP connection 15
Dynamic IP connection 16
Access to the network camera 18
5. Click OK 19
6. Click Next 19
7. Click Finish 20
Wi-Fi settings 21
Security mode 23
EAP-TLS or EAP-PEAP 24
PBC mode: 26
PIN mode: 26
Live View 29
Starting live view 30
Full-screen mode 30
Operating PTZ control 31
PTZ control panel 31
Setting/calling a preset 32
Network camera configuration 34
Configuring time settings 35
36
Configuring TCP/IP settings 37
Configuring port settings 38
Configuring PPPoE settings 38
Configuring DDNS settings 39
Configuring SNMP settings 41
Configuring 802.1X settings 42
Configuring QoS settings 43
Configuring FTP settings 43
Configuring UPnP settings 44
Configuring video settings 45
Configuring audio settings 47
Configuring ROI encoding 48
Configuring image parameters 48
Configuring display settings 48
Configuring OSD Settings 51
Configuring privacy mask 53
Configuring picture overlay 54
Configuring motion detection 55
Handling exception 58
Uploading to FTP 60
Configuring other alarms 61
Configuring PTZ 63
4. Click Save 68
Clearing a PTZ configuration 69
Storage settings 70
Playback 75
Log searching 77
Streaming video types 78
Managing user accounts 79
Anonymous visit 81
IP address filter 82
Viewing device information 84
Maintenance 84
Rebooting the camera 84
Restoring default settings 85
Upgrading the system 86
RS-232 settings 86
RS-485 settings 87
Appendix 1 88
Modify network parameters 89
Appendix 2 90

Comentários a estes Manuais

Sem comentários

ClareControls CH-THSTAT-W Guia do Utilizador Página 87

Comentários a estes Manuais

Manuais e produtos relacionados com Termóestatos ClareControls CH-THSTAT-W