ClareControls CH-THSTAT-W Guia do Utilizador descarregar pdf (Página 62)

54 Clare Controls IP Network Camera User Guide

Arming or disarming the camera

This section if for supported cameras only. Follow the steps below to configure all-day

arming for the camera with the wireless alarm, PIR alarm, motion detection, video

tampering, etc.

Notes

 The emergency alarm is enabled and armed by default.

 The arming and disarming function can be set by the remote control.

To arm the camera:

1. Enter the Remote Control interface.

Configuration > Camera Configuration > System > Remote Control

2. Select Arm from the Arm/Disarm drop-down list.

3. Set the arming delay.

Note: Arming delay refers to a time delay to arm the camera after you set it. You can

set the delay as 10 seconds, 30 seconds, 1 minute, 3 minutes, 5 minutes, or

customize the delay time.

4. Click Set to arm the camera.

To disarm the camera:

In the Remote Control interface, select Disarm from the Arm/Disarm drop-down list

and click Set to disarm the camera.

Note:

 You can press the Arm/Disarm button on the remote control to arm/disarm the

camera if the camera has already studied the remote control.

 The arming indicator glows red when the camera is armed and glows blue when

it is disarmed.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 91 92

Sem comentários

ClareControls CH-THSTAT-W Guia do Utilizador Página 62