ClareControls CH-THSTAT-W Guia do Utilizador descarregar pdf (Página 90)

82 Clare Controls IP Network Camera User Guide

Appendix 2

Port mapping

The following settings are for a TP-LINK router (TL-R410). The settings vary depending

on the router model.

To set port mapping:

1. Select the WAN Connection Type, as shown below.

2. Set the LAN parameters of the router as in the following figure, including the IP

address and subnet mask settings.

3. Set the port mapping in the virtual severs of Forwarding. By default, the camera

uses port 80, 8000, 554 and 8200. You can change the port values with the web

browser or the client software.

Example:

When cameras are connected to the same router, you can configure the ports of a

camera as 80, 8000, 554 and 8200 with an IP address 192.168.1.23, and the ports of

another camera as 81, 8001, 555, and 8201 with an IP 192.168.1.24. Refer to the steps

below:

Note: The 8200 port changes with the 8000 port with a constant value of 200. E.g. if the

8000 port is changed to 8005, then the 8200 port should be changed to 8205.

1 2 ... 85 86 87 88 89 90 91 92

Sem comentários

ClareControls CH-THSTAT-W Guia do Utilizador Página 90